Cylinder head gasket is produced from one piece of thin rubber and two metal pieces. The rubber piece hardly fits between the metal pieces
This part has the task of transmitting the rotational power of the car engine using a belt to rotate the pulleys of the hydraulic system pump, power generator and cooler compressor. This part is designed as three parts because it must repel the shocks and stresses of the hydraulic oil pump and cooler compressor to the crankshaft.
Crankshaft heads of Etihad Golden Asia Company are produced from the best raw materials.
The material of the inner part of the crankshaft head is metal, the material of the middle part is rubber, and the material of the outer part is also metal. The outer part has grooves for the movement of the belt. It is installed on the crankshaft axis by means of a stabilizer pin and a page. The middle piece acts like a spring-loaded gappling to repel blows. The rubber causes the foley to change from a rigid and flexible state to a piece with low flexibility, and the shocks created are rotated from the left and right, the steering wheel takes its maximum stroke or the car is turned on while the cooler is on, and tension is created. Do not enter the size of parts and engine.
In order to extend the life of this part, you should read the instructions in the car manual, which states that you should not start your car while the air conditioner button is on or the car wheels are in the most sideways position, because A lot of pressure is applied to the starter as part of the crankshaft head foley.
Crankshaft head gasket is an important part, it is necessary to check its condition, the high quality of this part reduces cost and time. Etihad Talai Asia company, using its high experience, supplies parts and spare parts of domestic cars with the highest quality to all parts of the country.
